NOTE:

1. The wipedclean ink outlet can also sealedwith scotch tape wether it's chip cartridge
　or not.

2. The lubricant on the piston rod will wear out after repeated uses, it's suggested to
　change new vacuum filler when friction occurred.

3. Run several clean cycles after reinstalled cartridge back to printer. if white streak
　still occurred, just leave it for at least 30 min or over night, to expel air trapped
　inside cartridge.

4. To prevent clogging on the printhead, the printer should be turn on time to time if
　not using for a long time.

NOTE:

1. The wipedclean ink outlet can also sealedwith scotch tape wether it's chip cartridge
　or not.

2. The lubricant on the piston rod will wear out after repeated uses, it's suggested to
　change new vacuum filler when friction occurred.

3. Run several clean cycles after reinstalled cartridge back to printer. if white streak
　still occurred, just leave it for at least 30 min or over night, to expel air trapped
　inside cartridge.

4. To prevent clogging on the printhead, the printer should be turn on time to time if
　not using for a long time.